246 results found.
Year: 2017, Volume: 17, Number: 3
... , M. R. Zolghadri, "FPGA-Based Systems (DAS), 2014 International Conference on. IEEE, pp. 11-15, Reconfigurable Control for Fault-Tolerant Back-to-Back Converter 15 – 17 May, 2014. doi:10.1109/DAAS.2014.6842419. Without Redundancy," IEEE Trans. Ind. Electron., vol. 60, ...
Terms matched: 1 - Score: 5 - 1,638k
Year: 2017, Volume: 17, Number: 3
... important to extract the maximum power output. The DC-DC converter is used to track the maximum power Figure 3 ... conditions. One or two Index Terms — DC-DC power converters, maximum power variables may be used in the ... "Short-current pulse-based maximum-power-point tracking method for multiple photovoltaic- and-converter module system," IEEE Trans. Industrial Electronics ...
Terms matched: 3 - Score: 34 - 2,175k
Year: 2017, Volume: 17, Number: 3
... . IV. RESULTS AND DISCUSSIONS The system control is implemented on a digital controller consisting in a computer, a data acquisition card and sensor boards. The Analog-Digital Converter converts the outputs of the airgap and current sensors. The computer determines the control outputs according to the control algorithm. Then, the Digital-Analog Converter converts the ...
Terms matched: 1 - Score: 6 - 2,636k
Year: 2017, Volume: 17, Number: 3
... [3-4], [11], [15-17], and (GUI) application. The DAQ device consists of an analog-to- digital (ADC) converter, field programmable gate array Support Vector Machines (SVM) [18-19] are used to (FPGA) and a USB first in first out (FIFO ...
Terms matched: 1 - Score: 8 - 1,622k
Year: 2017, Volume: 17, Number: 3
... 6(b) and Due to large dynamics involved in the distribution system, Fig. 9(b) are similar because the V2G system is only power converters connected to the power network for penetrated in the Load Bus(2) as described in Table V. charging and discharging the EVs are not modeled. ...
Terms matched: 1 - Score: 5 - 2,118k
Year: 2017, Volume: 17, Number: 2
... in normal mode and 3.8µA in sleep mode, interference generated by the 230V power supply and with the code running from RAM. The project offers propagate through AC-DC converters is considered a the elements for a complete healthcare IoT solution for high frequency disturbing device, if we take into applications in the medical field. In the ...
Terms matched: 1 - Score: 3 - 2,915k
Year: 2017, Volume: 17, Number: 2
... . Rodriguez, A. Timbus, and F. Effects of system architecture and converter topology design Blaajberg, "Online grid impedance estimation for single-phase grid- choices ... of the RTHNode 2  (12) output impedance of switched DC/DC converters, as R Node1  RS presented in [26]. Through considering ...
Terms matched: 2 - Score: 16 - 1,453k
Year: 2017, Volume: 17, Number: 2
... the following blocks were used: torque; T L – load torque; Ω m – mechanical rotor angular SM – synchronous motor; speed. FC – frequency converter; The electrical rotor speed is given by the derivative of the T 3/2 – block of the Clarke transformation; electrical rotor angle: PWM – ...
Terms matched: 1 - Score: 23 - 2,573k
Year: 2017, Volume: 17, Number: 1
... by Hall-effect current sensors (LA 25-NP). These -120 currents are fed to the DSP board through the analog-to- 0 3 14 2 5 6 7 digital converter. The third phase current is computed in Time [sec] Figure 7. The simulation results showing the tracking performance of the software program inside DSP control ...
Terms matched: 1 - Score: 3 - 1,332k
Year: 2017, Volume: 17, Number: 1
... Advances in Electrical and Computer Engineering Volume 17, Number 1, 2017 Boost Converter with Active Snubber Network Felix A. HIMMELSTOSS1, Ali Rıza DERIN2, Mihai ... [3-5]. We distinguish zero-current ZC quasi-resonant and zero- voltage ZV quasi-resonant converters. Other concepts are the zero voltage and the zero current transition concept or ...
Terms matched: 2 - Score: 108 - 1,305k